A.Mechanical Tensioner
1.Mechanical Tensioner in the installation should not be too large to force rotation, will affect the degree of mosaic pieces of the solid.
2.To prevent falling, and the case will damage the ceramic pieces.
3.Tighten the screws when installing the tension rod to align the axis of plane
4. When the model used does not match the diameter and do not force the
use of
5. Forbidden to join any oil in the damping-wheel. Do not open the self-regulation
6. Frequent replacement of wool circle, line the mouth to prevent clogging
7. Abnormal noise or over the line wheel does not turn, please change, because bearing worn.
8. If the rotation damping wheel slip, please pull the soiled cotton rubbing alcohol damping O-ring inside the wheel, so you can remove the wax inside the wire left in the dirt.
9. Production sites to keep clean, easy to wear a long backlog of dust Tensioner Parts
10. Around the bottom of the tension knob can spin, can not pull down
B.Magnetic Tensioner
1.Tension tension rod when the work shall not exceed the red line position.
2.In the course of only minor tension by the big, big tune is not allowed by the small
3.Hours required by the flat tension must be adjusted in the stop mode in order to avoid disconnection
4.If the adjustment of the tension pulse phenomenon appears, first right-hand tension adjustment screw to set maximum tension, then slowly return to the necessary re-adjust the tension in the vicinity
5.Tension in the installation should not be too large to force rotation, will affect the degree of mosaic pieces of solid
6.To prevent falling, and the case will damage the ceramic pieces.
7.Tighten the screws when installing the tension rod to align the axis of plane
8.When the model used does not match the diameter and do not force the use of
9.Forbidden to join any oil in the damping-wheel. Do not open the self-regulation
Frequent replacement of wool circle, line the mouth to prevent clogging
10.Abnormal noise or over the line wheel does not turn, please change, because bearing worn.
11.If the rotation damping wheel slip, please pull the soiled cotton rubbing alcohol damping O-ring inside the wheel, so you can remove the wax inside the wire left in the dirt.
12. Production sites to keep clean, easy to wear a long backlog of dust Tensioner Parts
13. Around the bottom of the tension knob can spin, can not pull down
14. Long time does not use or long-term use where there is tension instability in the stands, rotating the small to big, from big to small repeated several times, you can restore the initial state
15. If you are using the magnetic tension device with a cylinder, pressure not less than 5 kg
